===== Nine Eagles Solo Pro 180 3D - Standard Settings =====

Nine Eagles Solo Pro 180 3D (318A)

This model was started by ave1 and I added the rest of the settings needed. ave1 test flew the model with good results.
  * Low dual rates and positive expo to tame the heli down  * Throttle hold on the RUDD D/R switch  * 7 Point Throttle and Pitch Curves  * TX Power=100mW  * Channels=7  * Protocol=J6Pro  * No Fixed ID  * Stick Mode 2
If you need Stick Mode 1, 3, or 4 load the model into your transmitter then change the Stick Mode in the transmitter settings.

Model 42 is for deviation firmware v4 and the DEVO 6/6S/8/8S/10/12/12S.

* This model will not work for deviation firmware v2.1 or v3.

__Gyro Gain__ - These are the values I used then converted them to the deviation values.

Gear Switch

Pos 0: 25%

Pos 1: 75%

__Throttle Curve__

Normal: Custom Curve

ST-1: V Shaped Throttle Curve

ST-2: V Shaped Throttle Curve

Throttle Hold is active on RUDD D/R switch

__Pitch Curve__

Normal: -3* negative pitch. Hover at about half throttle.

ST-1: Full +/- 3D pitch curve. Zero degrees pitch at mid stick.

ST-2: Full +/- 3D pitch curve. Zero degrees pitch at mid stick.

__DR/EXPO__

Adjust D/R and EXPO to your personal preference.

Switch Position

0- ELEV D/R = 70% EXP +30%

0- AILE D/R = 70% EXP +30%

RUDD D/R = 100% EXP LIN

Switch Position

Switch Position

1- ELEV D/R = 100% EXP +30%

1- AILE D/R = 100% EXP +30%

RUDD D/R = 100% EXP LIN

Download the Configuration Settings File.

Right click the "model.ini " and select "Save Target As" or "Save Link As" depending if you are using IE or Firefox.

Install the configuration settings file into your models folder (See my How to video below).

This will over-right the current file so make sure that model slot doesn’t

have a model being used in it. If it does rename the configuration settings file

to another number that you have free.

Example: The file you downloaded is named model5 so change the “5" to another slot

number that you don’t have a model setup for. If you have model slot 6 open rename the file to model6

How to Import/Export Deviation Firmware Models

http://youtu.be/aXkvtbCXzsk

-

[[ .:nine_eagles_solo_pro_180_3d_-_standard_settings:model42 ]]