===== Walkera V100D01 - Beginner Settings ===== * Stick Mode 2 If you need Stick Mode 1, 3, or 4 load the model into your transmitter then change the Stick Mode in the transmitter settings. * Protocol=WK2401 * TX Power=100mW * No Fixed ID * Throttle Hold is active on RUDD D/R switch. Model 29 is for deviation firmware v4 and the DEVO 6/6S/8/8S/10/12/12S. * This model will not work for deviation firmware v2.1 or v3. __Fixed ID__ My model does not use a Fixed ID. If you used a Fixed ID with the original Walkera firmware you must clear the Fixed ID in the Receiver with the Bind Plug. If you don't clear the Fixed ID the model will not bind. If you want to use a Fixed ID you can enter the same Fixed ID you had for the original Walkera firmware. Example: Your original Walkera firmware Fixed ID was: 123456 Assign the Deviation Fixed ID: 123456 You can also assign any Fixed ID that you want to use. You don't have to use the original Walkera firmware Fixed ID. Clear the Fixed ID in the Receiver with the Bind Plug then assign any Fixed ID that you want to use. __DR/EXPO__ Adjust D/R and EXPO to your personal preference. Switch Position 0- ELEV D/R = 50% EXP +30% 0- AILE D/R = 50% EXP +30% RUDD D/R = 100% EXP LIN Switch Position 1- ELEV D/R = 70% EXP +30% 1- AILE D/R = 70% EXP +30% RUDD D/R = 100% EXP LIN Download the Configuration Settings File. Right click the "model.ini " and select "Save Target As" or "Save Link As" depending if you are using IE or Firefox. Install the configuration settings file into your models folder (See my How to video below). This will over-right the current file so make sure that model slot doesn’t have a model being used in it. If it does rename the configuration settings file to another number that you have free. Example: The file you downloaded is named model5 so change the “5" to another slot number that you don’t have a model setup for. If you have model slot 6 open rename the file to model6 How to Import/Export Deviation Firmware Models http://youtu.be/aXkvtbCXzsk - [[ .:walkera_v100d01_-_beginner_settings:model29_2014-01-25 ]]