Version 3.0.0 was released on

This is a major release of the Deviation firmware

IMPORTANT: You must install the filesystem along with the new firmware. Make sure to save your models first!

• Devo7e support
• Devo12 support
  • Note that the Devo12 support uses the Devo8 GUI and does not take full advantage of the larger screen yet
• New 'standard' GUI for helicopters

• Telemetry support for DSM2/DSMX
• New protocols
  • DSMX
  • Skyartec (needs CC2500 module)
  • WLToys protocol extensions
• Repetitive low-battery alarm
• Multiple hardware modules are supported
• Support for hardware modules with or without power amplifier
• PPM has more configuration options
• Support for multiple icons per switch
  • Also support switch icons for Devo10
• New 'permanent' timers
• Add error-catching code to make it possible to debug reboots/hangs

• Switches are now numbered (e.g.GEAR0, GEAR1). Deviation will properly convert old models, but older versions of Deviation will not properly support models made for version 3.0 or newer
• The channel scale is applied after the safety value. If safety is in use, make sure to check the values
• The toggle icon locations have changed. Generally all models will need to be reconfigured to use the new icons. This was unintentional, but not easily rectified at this point.
• If upgrading from a previous Deviation release and using an A7105 module (Flysky/Hubsan), the module will be initially disabled until you follow the directions here: https://www.deviationtx.com/forum/6-general-discussions/1572-flysky-module-users-you-need-to-read-this