DeviationWiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
===== Nine Eagles Solo Pro 125 - Beginner Settings =====

Nine Eagles Solo Pro 125 (125A)
  * No negative pitch for normal mode so you dont slam the heli down if you pull the stick down to fast.
Dont fly outside in wind in normal mode. You wont be able to pull the heli down if the wind takes the heli.

If you fly outside in wind use ST-1 or ST-2 which have full pitch curves which can pull the heli down in wind.

[li]Throttle Hold on the RUDD D/R switch.

Zero Degree Pitch when throttle hold is on.

This will help minimize damage in a crash as the swash and blades will be at mid stick zero degrees pitch. This will also help prevent a boom strike.[/li]
  * 7 Point Throttle and Pitch Curves  * Low dual rates and positive expo to tame the heli down  * Throttle hold on the RUDD D/R switch  * TX Power=100mW  * Channels=6  * Protocol=J6Pro  * No Fixed ID  * Stick Mode 2
If you need Stick Mode 1, 3, or 4 load the model into your transmitter then change the Stick Mode in the transmitter settings.

Model 45 is for deviation firmware v4 and the DEVO 6/6S/8/8S/10/12/12S.

* This model will not work for deviation firmware v2.1 or v3.

__Gyro Gain__ - These are the values I used then converted them to the deviation values.

Gear Switch

Pos 0: 38%

Pos 1: 75%

__Throttle Curve__

Normal: Custom Curve

ST-1: 100% Flat Across

ST-2: 100% Flat Across

Throttle Hold is active on RUDD D/R switch

__Pitch Curve__

Normal: No negative pitch. Hover at about half throttle.

ST-1: Full +/- 3D pitch curve. Zero degrees pitch at mid stick.

ST-2: Full +/- 3D pitch curve. Zero degrees pitch at mid stick.

__DR/EXPO__

Adjust D/R and EXPO to your personal preference.

Switch Position

0- ELEV D/R = 50% EXP +30%

0- AILE D/R = 50% EXP +30%

RUDD D/R = 100% EXP LIN

Switch Position

1- ELEV D/R = 70% EXP +30%

1- AILE D/R = 70% EXP +30%

RUDD D/R = 100% EXP LIN

Download the Configuration Settings File.

Right click the "model.ini " and select "Save Target As" or "Save Link As" depending if you are using IE or Firefox.

Install the configuration settings file into your models folder (See my How to video below).

This will over-right the current file so make sure that model slot doesnt

have a model being used in it. If it does rename the configuration settings file

to another number that you have free.

Example: The file you downloaded is named model5 so change the 5" to another slot

number that you dont have a model setup for. If you have model slot 6 open rename the file to model6

How to Import/Export Deviation Firmware Models

http://youtu.be/aXkvtbCXzsk

-

[[ .:nine_eagles_solo_pro_125_-_beginner_settings:model45_2014-02-04 ]]
DeviationWiki

User Tools

Site Tools

Page Tools
