Joomla says you aren't logged in
release_notes:5.0.0
Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
release_notes:5.0.0 [2016/04/30 12:56] Arnold [Minor Features / Bug Fixes] |
release_notes:5.0.0 [2016/05/25 09:56] Arnold [Minor Features / Bug Fixes] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ===== Version 5.0.0 (Unreleased) ===== | + | ===== Version 5.0.0 ===== |
- | ** NOTE: Deviation 5.0.0 has not been released yet. These release notes are a work-in progress** | + | **IMPORTANT:**\\ |
- | + | **You must install the filesystem along with the new firmware. Make sure to save your models first!**\\ | |
- | **IMPORTANT: You must install the filesystem along with the new firmware. Make sure to save your models first!** | + | **The configuration of hardware mods has changed since the previous 4.0.1 version. Instead of the tx.ini, they are in a new hardware.ini file, just like they were in the last nightly builds.** |
==== Installation ==== | ==== Installation ==== | ||
Line 34: | Line 34: | ||
* Support newer Devo12S (with Rev2 Epson LCD driver) | * Support newer Devo12S (with Rev2 Epson LCD driver) | ||
* Fix channel mapping when loading templates | * Fix channel mapping when loading templates | ||
- | * Remove hardcoded fonts to improve themability | + | * Remove hardcoded fonts to improve theme-ability |
* Protocol fixes | * Protocol fixes | ||
* YD717 - Fix channels for rudder, aileron, elevator | * YD717 - Fix channels for rudder, aileron, elevator | ||
Line 40: | Line 40: | ||
* YD717 - Enable high-rate mode | * YD717 - Enable high-rate mode | ||
* YD717 - Support receiver throttle saftey | * YD717 - Support receiver throttle saftey | ||
- | * YD717 - Don't hange the transmitter waiting fro a response from the model | + | * YD717 - Don't hang the transmitter waiting for a response from the model |
* Properly handle Tx mode in Hubsan protocol | * Properly handle Tx mode in Hubsan protocol | ||
* DSM2/X - telemetry display fixes. Support temperature display | * DSM2/X - telemetry display fixes. Support temperature display | ||
Line 76: | Line 76: | ||
* MJXq protocol | * MJXq protocol | ||
* H8_3d protocol | * H8_3d protocol | ||
+ | * Futaba S-FHSS protocol |
release_notes/5.0.0.txt (27039 views) · Last modified: 2017/05/17 08:03 by Texacate