Joomla says you aren't logged in
rf_module_installation:remove_skyartec
This is an old revision of the document!
Table of Contents
Removing an CC2500 module from a Skyartec 701
Step 1: Disassemble the NASA701 transmitter
The 1st step is to remove the back cover from the Skyartec transmitter. Remove the 9 screws from the back of the transmitter as well as the rubber sides.
Step 2: Remove the CC2500 module
Using a soldering iron with solder wick or a solder-sucker remove all solder connections to the CC2500 module. Removing enough solder to be able to remove the module will likely be difficult without wick or a sucker.
rf_module_installation/remove_skyartec.1460689264.txt.gz (98025 views) · Last modified: 2016/04/14 20:01 by PhracturedBlue
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
