Walkera RX601

Hi,
I successfully bind my Devo6/Deviation V 1.1.2 with Devo lady bird, and V100 D03 BL but I cannot bind my RX601 (Walkera Devo), I test it with 2 different Rx. Is any one already try it ?

Rgds.
Pascal.

I successfully bound a rx601 this weekend, no problems at all, works like a charm, also with fixed id. I'm using it with my T-Rex 450.

Did you already try resetting the receivers? Were they bound to some other tx before?

Hi,
Many thanks for answer. My Rx where all previously bind to my Devo 6 (using Walkera OS) and bind to fixe ID. I did try to press the reset button on receiver but nothing happen. Do you know the procedure to correctly reset and remove the the fix Id ?

Thanks in advance.
Pascal.

Thanks,
Unfortunately I did use the original random fix Id and did not note it before to install Deviation. I did not have the manual of the RX just manual of Tx and I agree with you it's not really clear. They also say to "pull out bind plug" but not even mention when and where to plug it...

there was no bind plug for my rx601, so i guess it's all about the "clean" button (instructions can be found in the devo6 manual). i think you should press the button, then connect to power, keep button pressed until the led will flash slowly and disconnect the power afterwards (the instructions in the devo8 manual are very similar so i guess the bind-plug-thing is just a mistake).

after powering it on again, you should be able to connect with a random id.

Many thanks,
Sorry I got busy the last few days, but I tried it, and it works. So procedure is :
- turn off TX
- press and hold clean button
- turn on RX by plug in 5V battery (I use USB mobile charger, plugged on Thro entry)
- wait for led blink aprox 1 per sec
- switch off RX
- Turn on TX
- Turn on RX (and it should work)

Nice flights.

Flyguy,

You say that you use it on your T-Rex 450 I'm interested by your config, is it a flybar or a flybarless ? (I'm looking for Flybar config)

Rgds
Pascal.

Hi,

it's a flybar heli. I can attach my config when I'm back home if you like (I setup everything and it seems to work well, but I didn't do a test flight yet).

Hi,
I did try setup one by myself from scratch, but I'm not mastering the software yet, and mix-up the channels. So if you can post your config I'am sure it will be useful. May be post it in usual Config forum, and specify Flybar in the title that will be helpful.

Many thanks in advance,
Rgds
Pascal.

i could test my config today and posted it in the config section. have fun.