Devo 6s tactil screen question

Hi ,

I have some pb with the calibrating of the touch panel on my devo 6s

is someone who have a working one could give me is value on the tx.ini file on deviation 3.00 ?

something like this

[touch]
xscale=197312
yscale=147271
xoffset=-404
yoffset=-20


on the fs file are from devos 8s , maybe the 6s is not correct

what are the standart valu on the original walkera devo firmware

thank in adavance

yep something like that but even after a calibration it'not working properly
.
I can go with the key touch on menu, but the calibration not work a least maybe the saving .

seem to work but after returning to main menu, can't use the tactil tool button to go back again on the setup menu and in the model menu

version is 3.00-c9608be and it the same with official 3.0.0 version

Any idea, or I'm doing something wrong

is someone can give me his std devo6s touche panel value ?

thxs

tazdevil wrote: is someone who have a working one could give me is value on the tx.ini file on deviation 3.00 ?

You can not copy the values from another tx; they might not fit for yours and make it worse. If you want to test, here are mine (from Devo8, but uses the same hardware and code as Devo6):

what are the standart valu on the original walkera devo firmware

The standard values are transmitter (not only tx model) dependent, individual after each calibration. And the original firmware does not tell what it uses.

You should check if the calibbration values are saved. Start the tx in USB mode (with "ENT" pressed when powering on) and look for the values. Start in normal mode, do a calibration and start in USB mode again to see if new values are saved.

After you have done the calibration, check the touch screen. YOu will see the coordinates in the box in the middle (first two values are X and Y). Move to the edges and corners and watch the values - should be near to 0/0 to 320/240.
The corners of the text box have (top left) X=85, Y=107 and (lower right) X=235, Y=132.

When calibrating make sure that you press every cross only once - this happened to me: I pressed the first one (top left) twice so the values were very bad and the touch screen not usable at all.

well

after investigation and test, after reloading the original devo firmware it appear that my screen do not work properly and randomly

so the tactil componant is dead....

Well, the radio as less than 6 month and has never been shocked aned the screen s dead

is someone know where can I find an new screen , cause don,t think the walkera service is easy

it will cost lighter to buy a new screen than refund the radio to the supplier...
thxs

I've no idea if or how but could touch part of the screen be replaced ?
Screen don't all come as standard with touch screen. Still wouldn't be that simple to do.

Somewhere has mentioned that all Devo screens come from one seller... (searching) ... found here .
But I have not found the Devo6/8 screen on their page.
Maybe you can repair your tx when only changing the touch screen as offered in addition to this screen: (Touch Screen(Mounting for customer by default)) .
EDIT: as SadSack mentioned it might not be easy but believe it will not be much more than to solder wires to the right places. The four connections look quite the same...