New Firmware V5.0 something wrong of Devo6S

I just updated new firmware V5.0 for my Devo 6S. I checked all item and chose Helicopter mode
3 servo SwashType 120 and DEVO Protocol for my Walkera Mini CP, I found of servos wrong control,
the AIL and ELE control signal interchanged !! I have tried another one Skyartec Nano CP also same
problem of ELE and AIL control !!

I don't know how to fix it ???

you need to swap the swash type to 120x, this issue was caused by someone who complained that his heli was working wrong when he didn't try 120x, now the majority of heli's who have the correct swash/servo setup have to use 120x instead of the rare few who have it backwards

I'm not sure about the mini cp but some of the cheap flybarless fcb's require the tx to do the swash mixing (hisky 100/80 and their wltoys counterparts spring to mind iirc) as they don't do it themselves

Modell Heli....simple 4 channel setup , no swash mix
plus hold = channel 5
plus pitch = channel 6
plus gyro on channel 7 ( if you want to change something for different flight modes).

then that will be his problem lol, and though it's not pertinent here i just checked and yeah the fbl100/hcp100/v922 and the fbl80/hcp80/v933 do require ccpm swash mixing in the tx

I do have a Mini CP (bought it RTF with a Devo 7E so I could try deviationTx on the cheap).

It doesn't need swash mixing.

And best to stay way from channel 7. It'll switch you from heading hold to the undocumented rate mode, which you almost certainly don't want to use. Unless you want a cheap-to-crash not-a-simulator way to practice flying in rate mode.

Yes, I agree ! firmware V5.0 of Model Heli is without mix of output, very big difference of V4.01 , last year my DEVO 6S firmware V4.01 setting very easy , I did not needed set swash or something it could control my Mini CP and many my small helicopter ……

But update new firmware V5.0 after gave me many trouble !!

So, does it finally work when you set heli / CCPM mix to NONE for FBL?

Well, as pointed out in several threads, it MIGHT still be required that you need to swap AIL/ELEV Cyclic1/Cyclic2 channels if you work with any of the provided heli templates - using 6CH heli template (even for NONE setting) - might be switched depending on CCPM/FBL.
Quite hard to test all scenarios and write the template that it works for all of them.

Are you using advanced or standard heli mixer GUI?

Just see the other heli threads and open BugTracker tickets (and linked threads)...


Thomas

What about BugTracker ?? Server is down?? Link not working: www.deviationtx.com/mantisbt/

Deviation 5.0 as been released: www.deviationtx.com/forum/6-general-disc...eased?start=60#53953

Heli problem / workaround description including link to new "heli summary analysis developer" thread.
Developer thread includes updated heli templates (working for advanced GUI NONE/FBL+CCPM120, standard GUI NONE/FBL on my side - not or only partly CCPM120)

Thomas