Fail safe issue

Next puzzle I am trying to solve:

I am running a Mini V-Bar with Lemon Rx DSM2 Sat's.

I was flying this around with a modded Devo 7e and everything was working great.

Now that I got a Devo 10 and switched to the Devo 10 I can not seem to get the Fail Safe to work properly.

Fail safe value is set to -100, same as it was on my Devo 7e, However, when I turn the Tx off to test this the heli powers up to about 10% power and spins at a very low headspeed.

What could possibly be the issue? Any ideas?

I think you will have to dig into this issue a little more. And I don't believe it has to do with Deviation or the Devo radio.

There's a couple of points for failsafe from what I understand.

Failsafe for when signal is lost between RX and TX.

Failsafe for when signal is lost between RX and ESC.


In your case, I think you're talking about the Failsafe for when the signal between RX and TX.

Look into the Lemon RX failsafe. I remember it defaulting to the value when it was bound. Something like that.

Ok i'll try that route. I bound with TH on so it should work if that is the case.

Yes I am talking about when Tx and Rx loose signal.

Thank you for the response! I find it weird that it did not have this issue when I was running the 7e.

Well I feel silly. I forgot to reset the "Fail safe value" button in the VStabi software.

When I went through initially it didnt offer the option but now it did.

Works perfectly again.

Thanks guys!