Has anyone figured out a throttle kill for 350qx?

More
07 Apr 2014 02:59 #22187 by oldgamefreak
I'm new to all this custom programming and kinda new to the world of flying. I have found I love my Devo 8s but the BLADE 530 qx program doesn't have a real throttle kill. If I move the trim to -110 it will kill the props but is a slow process. I can also hit the RTH switch and it will kill the props but again is slow.. I would like to use the ELEV or AILE switch to kill the props. Is there any way to make of of them (when switched) just put out -110 throttle? I think this might work as a kill switch. If I set my throttle to -110 at the lower limit my props will never arm. I know I should mess around with it but i'm afraid if i mess around too much I'll totally mess up base "map"

Please Log in or Create an account to join the conversation.

More
07 Apr 2014 04:13 #22190 by FDR
Increase the scale values (=travel adjust) on the channel config page of the throttle channel...

Please Log in or Create an account to join the conversation.

More
07 Apr 2014 04:29 #22191 by oldgamefreak
Replied by oldgamefreak on topic Has anyone figured out a throttle kill for 350qx?
If I adjust that the motors will never arm. Anything below 100 and they wont spin up..

Please Log in or Create an account to join the conversation.

More
07 Apr 2014 07:20 #22195 by FDR
Yep, that's why I said to increase (not decrease) them to say 125%...

Please Log in or Create an account to join the conversation.

More
09 Apr 2014 00:53 - 09 Apr 2014 00:55 #22252 by oldgamefreak
Replied by oldgamefreak on topic Has anyone figured out a throttle kill for 350qx?
Sorry that's what I meant to say if I go to 110 or 125 they won't spin up BUT you got me thinking and I figured it out. I increased the "safety" value (that appears to be associated with the throttle hold) to -110%. Now when I flip the RUD0 switch to 0 it kills the props. When I flip it to 1 it starts the props.
Last edit: 09 Apr 2014 00:55 by oldgamefreak.

Please Log in or Create an account to join the conversation.

Time to create page: 0.043 seconds
Powered by Kunena Forum