So what's the trick to get a bind with 1202

I have used the bind jumper and cleared the id and set my tx to devo,12channel and I have unplugged the jumper when it started flashing slow then I clicked the bind button but no luck let me guess go back to the old firmware then turn off fixed id which cant be done in deviation Geez O Peetz is there anything that works according to the instructions Ha Ha I finally got it. I was doing some searches that led me over to a thread on rcgroups and I remembered someone had said toturn the fixed id off but I could not in deviation so I decided to try and delete it and it worked. But I have some issue's throttle channel glitching bad, none of my switches are working for the rates and such.

No not for the receiver it does not... But clearing the id in the tx seems to, other wise I would not of got bind to work with deviation. To get it to work I had to CLEAR the 123456 from tx then it let me use the inti and then the receiver went solid. Now every time I turned on the TX it tried to bind automatic so to stop that then I made a new id and all is well. So if the deviation manual was a bit more specific I would have not had another troublesome night. all is well now. Well that's not fair of me to say.... If both manuals were a bit more clear I would have got it to bind in minute's instead of hours. Like my Airtronics read the manual bind the receiver and done in a few minute's.

OK I have all 4 channels working,now I'm going to try and switch my throttle hold off the switch to the aux 6 harder to spin it then to turn the knob. That way you don't bump it trying to reach for a switch. I also need to see about getting the dual rates switch's working.