Throttle hold & negative pitch

Hi there,

I'm using the Standard interface. When I engage throttle hold the collective goes full negative.

Is there a way to adjust the negative pitch, when throttle hold is used, while using the standard gui?

Thanks in advance...

JL

Anyone done this before?

There is a separate pitch curve for when in "throttle hold" mode. In standard interface, go into pitch curve settings, then scroll through modes until you get to "thr hold" mode. You likely have Enabled set to ON. This is the curve when you hit throttle hold switch. If you set Enabled to OFF then I suspect it disables separate pitch curve when throttle hold is activated, but I haven't tried that.

I like separate throttle hold pitch curve, and I have mine set linear from -100 to +100 because I use that mode to tune my heli and FBL controller on the bench without having to physically disconnect the motor leads. But I've also made the mistake during flight of hitting TH while also pulling pitch stick full negative (old habits die hard), which tends to cause more crash damage.

Boy, do I feel stupid...

Thanks for pointing the settings out for me.