Hold switch damaged

Nothing changes and Hold FmodE work together, or one excludes the other.
The slopes are below the display how do I remove it?

In case you can not solve, someone explain to me would know how to get around the problem? Perhaps adding buttons? Thank you very much, I will not throw it ...

Well, if you tried all of my suggestions, including re-flashing of a fresh nightly build firmware with proper hardware.ini for your switch configuration, and still having problems, I am pretty much all out of ideas.

Maybe upload your hardware.ini and model.ini so we can have a look at them?


One other thing is, on a picture of your board mods that you uploaded:



Some of the connections to the CYRF module are obscured by the red and white wires leading to the 3.3v/VDD. Can not really see what is going on under there, but some of the solder beads appear to be very close to being in contact with each other. Not sure if that could result in your switch error if there was some kind of short at one of those points, but you might want to check and see if there is some tiny, stray, beads of solder causing havoc.

Other than that, I don't have any more ideas.

Now, for try, I'm without the module and have the same problem.

I'm sorry, yes the two pins that you indicated and that I have circled, the tester always give they in short circuit. Could you indicate the link of these changes? So I try to do them. Thanks

Yes, at this point use Hold that will work both Hold that FModE in pairs. I add the missing links, exploit FModE as first additional key and try to put a trigger button on the back or the left I use to flip. Hopefully functions. Then from what I understand it would be enough to understand how to assign different keys through. ini