7e channel error message on the start screen

More
25 Jul 2016 04:56 #52122 by casey62
I don't understand the format of this forum, so I'm going with new topic. When I switch on my TX, instead of saying Deviation on the screen, it says ch1 is 0% safe = -100% I got it to bind to the Inductrix once, but I think that time it did start with the Deviation screen. The inductrix went up and down, but no response to right stick. I checked for that and it was in mode 3, but when I turned the TX on again it was back to the channel 1 error message. The message said ch1 is 9% before I did stick calibration.

Please Log in or Create an account to join the conversation.

Time to create page: 0.024 seconds
Powered by Kunena Forum