New Jumper T8SG V2 plus has unstable "mixer output

Start
Prev
1
Next
End

rpknowlton
Topic Author
Offline

13 Dec 2018 13:43 #72066 by rpknowlton

New Jumper T8SG V2 plus has unstable "mixer output was created by rpknowlton

my new jumper has unstable stick control outputs, all the channels jumper up and down. is this a software/firmware problem or hardware?

Please Log in or Create an account to join the conversation.

Gerry
Offline
Bbrad

13 Dec 2018 22:08 #72069 by Gerry

Replied by Gerry on topic New Jumper T8SG V2 plus has unstable "mixer output

have you calibrated the sticks and switches?

Devo 7e A7105 NRF24L01 CC2500 2x3 way & voice, Devo 12e 4 in 1 & voice.
FFS (Forever Fixing Stuff)

Please Log in or Create an account to join the conversation.

rpknowlton
Topic Author
Offline

13 Dec 2018 23:05 #72071 by rpknowlton

Replied by rpknowlton on topic New Jumper T8SG V2 plus has unstable "mixer output

I new to this radio, I tried but not sure it took.

Please Log in or Create an account to join the conversation.

rc manic
Offline

13 Dec 2018 23:50 #72072 by rc manic

Replied by rc manic on topic New Jumper T8SG V2 plus has unstable "mixer output

What type of batteries are you using? I had this same problem with 4 AA Eneloop batteries. Switched to Lipo, and at 8.4 V, problem has resolved. Also twisted wires of gimbals as others have suggested.
Seems the hardware likes a higher voltage.

Please Log in or Create an account to join the conversation.

rpknowlton
Topic Author
Offline

14 Dec 2018 12:32 #72073 by rpknowlton

Replied by rpknowlton on topic New Jumper T8SG V2 plus has unstable "mixer output

tried both 4 AA and 2 cell lipo. same results. didn't see where someone talked about twisted wires

Please Log in or Create an account to join the conversation.

rc manic
Offline

14 Dec 2018 16:17 #72074 by rc manic

Replied by rc manic on topic New Jumper T8SG V2 plus has unstable "mixer output

Read this:

www.rcgroups.com/forums/showpost.php?p=39601501&postcount=1118

Please Log in or Create an account to join the conversation.

rpknowlton
Topic Author
Offline

15 Dec 2018 00:42 #72076 by rpknowlton

Replied by rpknowlton on topic New Jumper T8SG V2 plus has unstable "mixer output

Took a look at the site. Thanks a lot RC Manic

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Time to create page: 0.054 seconds

Re-enable mobile display