Flysky FS-NV14 2.4G

What happens if 4IN1 is attached to Flysky FS-NV14 2.4G?

Shouldn't you ask Flysky that question ?

That should work fine with deviation Tx, it is AFHDSA 2A, toghether with ibus should perform nice. I have one but not yet flown.

I did not like the Flit Series aftermarket receivers I had much less range than with original Flysky, but they were too big.
.

The Flysky FS-NV14 is a TRANSMITTER !!! not a receiver so how exactly would it work with DeviationX. It is OpenTX based. The Devo 4in1 module is not the same as the 4in1's used in OpenTX radios as they have the firmware built into them. DeviationTX manages the protocols directly and just outputs to the relevant chips.

Ah sorry you are right, I thought it was about the FlySky FS-X14S which is there new micro receiver.Which should work with deviation.

The Nirvana runs open TX, noideaif it can control 4in1 multimodule, ask the open tx forum.

The question was bad. My Jumper T8SG can no longer be connected via USB and will not be recognized by the PC, so I gave up and purchased the Flisky FS-NV14 but the JP4in1 has not yet arrived! The original question is, if JP4in1 is installed on NV-14, can it be used like Jumper T8GS? I don't know anything difficult, so I want to borrow your wisdom. Thank you.

That radio runs OpenTX so yes, once you plug in the module it should work just fine.