1. Forum
  3. General
  5. General Discussions
  7. T8SG V3

T8SG V3

More
29 Nov 2020 12:39 #77069 by motiro50
T8SG V3 was created by motiro50
Bonjour a tous,

J'ai une jumper T8SG V3 et j'aimerais régler mais AUX4 et AUX5 pour qu'ils sois proportionnel et non tout ou rien!
Pour pouvoir régler mais Gain sur mon Naza V2.
Merci d'avance bon week a tous.

Please Log in or Create an account to join the conversation.

More
29 Nov 2020 14:51 #77070 by propnut
Replied by propnut on topic T8SG V3
Désolé je suis anglais et donc ma réponse sera en anglais.

Go into mixers, create a simple mix and make the src Aux 4 or Aux 5 and that mix will be proportional.

Please Log in or Create an account to join the conversation.

More
29 Nov 2020 16:01 - 29 Nov 2020 16:14 #77071 by motiro50
Replied by motiro50 on topic T8SG V3
Je fait ce mix la mais il n'est pas proportionnel ?
il fait 100/-100 et ne s'arrêt pas entre les deux!
ma courbe est 1a1
Last edit: 29 Nov 2020 16:14 by motiro50.

Please Log in or Create an account to join the conversation.

More
29 Nov 2020 16:24 #77072 by propnut
Replied by propnut on topic T8SG V3
I have just tested this and it is fully proportional

[channel5]
template=simple
[mixer]
src=AUX4
dest=Ch5
curvetype=expo
points=0,0

Please Log in or Create an account to join the conversation.

More
29 Nov 2020 16:39 - 29 Nov 2020 16:43 #77073 by motiro50
Replied by motiro50 on topic T8SG V3
j'ai fait
channel 5
simple
source: AUX4
curve: expo
scale: 100
offset: 0

et toujours pas proportionnelle!
j'ai peut etre un beug dans le firmware?
Last edit: 29 Nov 2020 16:43 by motiro50.

Please Log in or Create an account to join the conversation.

More
29 Nov 2020 16:47 #77074 by propnut
Replied by propnut on topic T8SG V3
Delete the model and create a new one and see if that makes a difference.

Please Log in or Create an account to join the conversation.

More
29 Nov 2020 16:52 #77076 by motiro50
Replied by motiro50 on topic T8SG V3
je l'es fait mais rien ne change le problème reste le même!

Please Log in or Create an account to join the conversation.

More
29 Nov 2020 17:24 #77077 by gdenton
Replied by gdenton on topic T8SG V3
Did you move the dials to each end during calibration?

Please Log in or Create an account to join the conversation.

More
29 Nov 2020 17:40 #77078 by motiro50
Replied by motiro50 on topic T8SG V3
je pensais avoir bien fait la calibration mais je n'avais fait que les stick!!je viens de refaire une calibration des stik et aux et tout fonctionne très bien!
Grand merci a vous. Vous est au top!

Please Log in or Create an account to join the conversation.

  1. Forum
  3. General
  5. General Discussions
  7. T8SG V3
Time to create page: 0.044 seconds
Powered by Kunena Forum
Re-enable mobile display