protocol ne260_nrf24l01 for SoloPro Devo7E build

Start
Prev
1
Next
End

blackmoon
Topic Author
Offline

08 Apr 2015 07:34 #30901 by blackmoon

protocol ne260_nrf24l01 for SoloPro Devo7E build was created by blackmoon

I would like to test this protocol, I have a solopro brick that I want to use on a micro plane.
Should I just add the following lines to the makefile in the protocol directory ?

Thank you.

ifndef BUILD_TARGET
....
PROTO_MODULES += $(ODIR)/protocol/ne260.mod
....
else #BUILD_TARGET
....
$(ODIR)/protocol/ne260.mod : $(ODIR)/ne260_nrf24l01.bin
	@echo Building 'ne260' module
	/bin/mkdir -p $(ODIR)/protocol/ 2>/dev/null; /bin/cp $< $@
endif #BUILD_TARGET

Please Log in or Create an account to join the conversation.

PhracturedBlue
Offline

08 Apr 2015 14:08 #30902 by PhracturedBlue

Replied by PhracturedBlue on topic protocol ne260_nrf24l01 for SoloPro Devo7E build

yes assuming you are building for the devo7e. You also need to un-comment the line in protocol.h

Note that I know the protocol doesn't work. I just fried my Rx before I could figure out why. Unless you have access to an SPI and familiarity with capturing data, it is unlikely you'll get too far.

Please Log in or Create an account to join the conversation.

blackmoon
Topic Author
Offline

08 Apr 2015 15:49 #30909 by blackmoon

Replied by blackmoon on topic protocol ne260_nrf24l01 for SoloPro Devo7E build

Bummer, I thought it worked, should have known if it wasn't built, it was for a good reason... I do have a SPI but never got the time to involve myself in learning how to use it, and that won't change in the near future. So I'll just use the ppm module I bought from Kile some years back.

Thank you for the reply.

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Time to create page: 0.045 seconds

Force desktop display