Walker Super CP for 7E

This is what I am using - cut off Tom Z's beginner's template. I have added a little negative pitch for flying in the wind. The picture is off here as well but I can't recall who posted it...

Well that sucks....

hazzanz wrote: This is what I am using - cut off Tom Z's beginner's template. I have added a little negative pitch for flying in the wind. The picture is off here as well but I can't recall who posted it...

I am totaly new in programming a Tx for a helicopter too.

For what is channel 7 in this config file?

And if there is a little bit negative pitch in this file in whitch position should be my throttle stick at binding?

SilbernerSurfer wrote: ...

And if there is a little bit negative pitch in this file in whitch position should be my throttle stick at binding?

The amount of pitch programmed in doesn't make any difference, just make sure the throttle stick is at the lowest position.

FDR wrote: Ch7 used to be the gyro channel for the DEVOs...

Thanks a lot FDR and Waldo.

Can i use the silver buttons on the Devo 7e for the gyro channel?

hazzanz wrote: This is what I am using - cut off Tom Z's beginner's template. I have added a little negative pitch for flying in the wind. The picture is off here as well but I can't recall who posted it...

How can i get the model file and the bmp in my nightly build?

I have tried it, but after copy and paste and switch on the tx it shows "bad/missing protocol".

This happens if you did not copy the "protocol" folder from the devo7 file system on your tx. Has nothing to do with model configs or icons.

The protocol file is added to file system. The devo 7e works perfect until i add the new model file from above.

What is the excactly way to add this model file to the devo 7e?

Just put it in the "models" folder. Did you rename it? It must have a name like modelXX.ini where XX is a unique number between 1 and 99 and they have to be used without any gaps in numbering (search stops if a number is unused; overwrite a model for which you haven't made a config or choose the next free number). Otherwise it will not be found.
But I don't believe that a wrong named file will harm.
...I tested the file in the emulator. Files with wrong names are not recognized, nothing more happened.

Yes, i tried it this way i think. I will try once again. Thanks for the help rbe.

It works now, thx a lot.