Old V120d02 and wk 2603 transmitter

hello everybody

I'm new to this forum .... and I need your help!
I have a V120D02 (old model) with Wk-2603 old old transmitter... so I bought a DEVO8S and I installed Deviation V 3.0.0 (nigthly builds) and almost everything works ... except models V120D02S downloaded here. Is there any problem with the channel numbers compatibility between those tx?
I do not understand! Can you help me? thank you

As far as I know the V120d02 and the new S have different receivers so there might be a difference in the settings. If you walk through the deviation manual and compare the settings with those published by Walkera for the WK2603 you should see if there is a difference.
There is also a good howto which describes the way to get a FBL heli configured: http://www.deviationtx.com/forum/how-to/1226-how-to-set-up-fbl-helis-on-custom-firmware

thank you for your answers
I tried to change the protocols according to different models but the binding problem arises sometimes. the led of the receiver will turn off at the end of the bindind process and sometimes cyclic not work???
What can be the difference between the receivers? rx2610V (old one) and rx2636H-D
I will read "fbl heli" and continue my test ...

Hi everyone
I come back with the same problem and many questions! (i read V2.0 / V3.0 manuals and How to set up FBL helis...but my english is not so good!! )
I still have not succeeded to make my old V120D02 (with rx2610V for TX WK-2603) works with my DEVO8S under Deviation 3.0. (all works great with my V200D03!)
I tried all Walkera protocols, the binding seems to work with WK2801protocol, but only the throttle and rudder work. I first got here a model for V120D02S but it did not works.
Then I created a model for FB heli. So I programmed the model the same as my WK-2603 i.e Swashplate 120, ELE channel to Cyclic 1 ans AIL channel to Cyclic2 ...
I do not know which channel to put PITCH and Gyro?
Can you help me? I'm going crazy!.
Thanks

And if FDR's suggestion still doesn't work try lowering channels in w2801 protocol to 6.
Had same problem and at the time was trying so many things I can't remember exactly what it was that fixed it.
Rod

I also had some trouble with my old v120d02 and Deviation.
Heres my ini (devo10), perhaps this can help you

hi guys
Thank you for your help
I try everything and I tell you....

This is great! it works!

Programming the 2801 Protocol with 6 channels ... and also reversing the PITCH channel!

Thanks thanks thanks!

I will not be crazy ... this time !