14 Jan 2014 01:08 - 15 Feb 2014 23:33 #18491
by Tom Z
This model will work on the following helicopters.
- Blade SR 120
- Blade mSR/mSR-X
- Blade mCX/mCX2
- Low dual rates and positive expo to tame the heli down.
- Throttle hold on the RUDD D/R switch.
- TX Power=100mW
- Protocol=DSMX
- No Fixed ID
- Stick Mode 2
If you need Stick Mode 1, 3, or 4 load the model into your transmitter then change the Stick Mode in the transmitter settings.
Model 25 is for deviation firmware v4 and the DEVO 6/6S/8/8S/10/12/12S.
Flight Mode switch on "0" = Helicopter will be tamer, soft throttle response
Flight Mode switch on "1" = More responsive, normal throttle response
Flight Mode switch on "2" = More responsive, normal throttle response
Throttle Hold is active on RUDD D/R switch
Channel 5 affects rate settings of the 5-in-1 Control Unit.
Use the Gear switch to switch between high and low rate.
DR/EXPO
Adjust D/R and EXPO to your personal preference.
Switch Position
0- ELEV D/R = 50% EXP +30%
0- AILE D/R = 50% EXP +30%
RUDD D/R = 100% EXP LIN
Switch Position
1- ELEV D/R = 70% EXP +30%
1- AILE D/R = 70% EXP +30%
RUDD D/R = 100% EXP LIN
If the tail is too touchy for you add some positive expo.
Try +20%. EX: RUDD D/R = 100% EXP +20%
Download the Configuration Settings File.
Right click the "model.ini " and select "Save Target As" or "Save Link As" depending if you are using IE or Firefox.
Install the configuration settings file into your models folder (See my How to video below).
This will over-right the current file so make sure that model slot doesn’t
have a model being used in it. If it does rename the configuration settings file
to another number that you have free.
Example: The file you downloaded is named model5 so change the “5" to another slot
number that you don’t have a model setup for. If you have model slot 6 open rename the file to model6
How to Import/Export Deviation Firmware Models
-
Last edit: 15 Feb 2014 23:33 by Tom Z.
Please Log in or Create an account to join the conversation.
