I hate to ask for help from you guys again as I'm sure you have so many others asking and I can't begin to thank you enough for all the help I've received in the past through reading posts etc. But once again I'm stuck, it's been awhile since I've frequented this forum of geniuses, so I'm catching up to where I was before. I am also looking for my friend and mentor victzh, who I've not talked to for quite awhile. I sure hope he is okay. Again, thank you all for youre help and this brilliant tool you've given to the RC world.
I am trying to setup a Devo 10 to toggle flight modes in a NAZA 2v. I have it setup like this because it requires different areas highlighted but I think I'm going about this the wrong way.it's moving the point close to where it triggers the modes. I'm confused. Thanks for your time and patience in advance.
[channel6]
template=complex
[mixer]
src=AIL
dest=Ch6
switch=FMODE0
scalar=50
usetrim=0
curvetype=fixed
[mixer]
src=AIL
dest=Ch6
switch=FMODE1
scalar=0
usetrim=0
curvetype=fixed
[mixer]
src=AIL
dest=Ch6
switch=FMODE2
scalar=-50
usetrim=0
curvetype=fixed
[mixer]
src=AIL
dest=Ch6
switch=RUD DR0
scalar=50
usetrim=0
muxtype=add
curvetype=fixed
[mixer]
src=AIL
dest=Ch6
switch=RUD DR1
scalar=-50
usetrim=0
muxtype=add
curvetype=fixed
[mixer]
src=AIL
dest=Ch6
switch=GEAR0
scalar=0
usetrim=0
muxtype=add
curvetype=fixed
[mixer]
src=AIL
dest=Ch6
switch=GEAR1
scalar=-70
usetrim=0
curvetype=fixed
