model.ini for aurora 90 w/frsky reciever

I've got the 4 in 1 in a 7e, all other 3 cept 2500 verified working (2500 not direct to mcu) and just need some verified setup to the frsky receiver, the aurora 90 came to me with built in (bangood) frsky.


Thanks Larry

That should work.

Didn't bind with mine, I noticed an id of 111 and no fine tuning on freq?

Do you have brerb as the switches and functions?

Larry

Ah, sorry.. that was from an outdated backup.
Try this one. The fine frequency value may have to be changed for your specific reeiver.

4 Switches are set up, two for 3 position, 2 are 2-position.
Hold is Aux3 (Ch 7), Fmode is Aux2 (Ch 6), the 3 position switches are Aux 1 and Aux 4.
You may have to shift the settings around some.. it's matching my personal "usual" setup for quadcopters, not specifically the aurora.

1. used your exact values to bind, worked.
2. Do you have an icon for the Aurora 90, hmini
3. I see ch 7 hold and ch 6 mode
ch 5 & 8 3 pos sw do what? sorry not an expert on deviation

I have added the 2 - 3 pos sw on my 7e

Larry

2. No. I'm using a generic quadcopter icon.
3. The 3 position switches are usually unused for me, but you can assign them i.e. to Acro/Horizon/Angle in beta/cleanflight. On my copters, I assign Hold to Arm, and Fmode to beeper (to find the quad if it crashes).

Gotya, thanks again 1st response to a two week long quest to get frsky to work, now I can put all my mini quads w/frsky on the 7e.

Larry