Eachine E010 inductrix clone data captures

Thanks for your help goebish

How do i select the E010 format?
just put loaded your file in the models and it still doesnt bind.

I fiddled some more but can't get headless to work properly. When i push left hor. trim button the led on the E010 start blinking indicating headless.
As long as the rear of the quad is facing to me it flies but as soon as i turn the E010 for 180 degree the problem starts. Meaning aileron stick to the right i need a lot of stick travel to get it flying in that direction.

But with barely any aileron stick to the left it's shooting left like a rocket and i need full right stick to stop it and i need to keep the stick almost full right to prevent it going further to the left. The same happens with forward and back movement when the quad is turned 180 degrees in headless mode.
I don't know what i'm doing wrong so i gave up. Perhaps someone can share an ini with a correct working headless mode thanks.

goebish wrote: Highlight "MJXq" in Model setup menu, press enter then select E010 sub-format.
Start from a fresh model, I see some stuffs are missing in your .ini ...

my only options are WLH08,X600,X800,H26D?

Thanks! i had a slight feeling it had something to do with dyntrim added or substracted in a particular direction. So in that case my ini should be ok
I looked at the ini you posted, and for ch3 i noted scalar and scalar min = 150 should i add that to my ini? Thanks.

goebish wrote: That means you haven't flashed the latest .dfu and copied the .mod files (you're running an older version of deviation).
Install the latest nightly.

Sorry about this.
Do i delete all my files and replace the whole lot with the nightly?

What about the debug zip file?

Thanks

Hello, je doit installer deviation-devo7e-256-v5.0.0-28fd02d.zipdeviation-devo7e-256-v5.0.0-28fd02d.zip or deviation-devo7e-v5.0.0-28fd02d.zipdeviation-devo7e-v5.0.0-28fd02d.zip ?

Be good to have instruction on how to install "nightly builds"
For NooBs

goebish wrote: @Alias_Hendrik, can you check if this build fixes the issue with headless mode please ?
Devo 7e

Installed the build but the E010 refuses to bind. I checked for the correct version on my 7E and it's installed.

oups! the MCU ? j'ai ça nRF24L01 CC2500 a7105 plusieurs rf 3 en 1 module sans fil pour l'émetteur de devo instalé sur ma devo 7e, c'est le MCU?