Eachine E010 inductrix clone data captures

MAny many thanks 4 quick answer but interesting thing that with wltoys v911 v977 cheerson cx-10 works ok

I gave it a quick try with the Jumper T8SG Plus on an Eachine E010. It changed from not binding at all to binding, but without having control. The propellers are spinning right away, but stick input do not really seem to correlate with the copters behavior.
However, this is still a bit better than not binding at all, right?

Which protocol should I use for test build? the same protocol MJXq->E010 ?
I will try it by my T8SG V2, it does not bind with E010 now!

I built it and tried it with a friend and it worked fine with two people. The transmitter is T8SG V2 Plus. The frequency adjustment seems to work at -50 to 55.

It worked perfectly on my T8SG V2, thank you Goebish.

After flying several times.
After confirming the frequency adjustment again, I received a report that it worked in the range of -127 to +50.
His E010 is an aircraft that worked well with the conventional protocol.
I think that frequency adjustment is necessary.

It works right out of the box on the Jumper T8SG Plus, no adjustment necessary! Thanks for your awesome work goebish!

It worked perfectly on my (DEVO 7E 256), thank you Goebish. You are a Genius!

Ok,I see!The Bayang protocol works well now!Thanks your professional answer.

Another confirmation it worked with Devo 7E and installed 4-in-1 module. Although not initially right after installed Deviation.
Here are some more detail and "my way" to bind E010.
Instead stock transmitter wanted to use Devo 7E. Initially E010 did not bind to Devo 7E and 4-in-1 mod with Deviation v5.0.0 using MJXq > E010 protocol. Replaced and Installed Deviation (search and see Deviation forum for "Eachine E010 inductrix clone data captures" post #73920). Again initially did not bind. even after adjusting the frequency as suggested in this forum topic. Eventually I found the solution. This is my way to bind: 1) Create model E010 as usual. 2) Choose E010 protocol. I use 10mW, and in my case adjust frequency to -127. 4) Make sure the E010 battery is not connected yet. 4) Move throttle stick up about 1/3 from bottom position (not to the maximum), selection should be on "bind", press "enter" to bind. Ignore error message (not safe). 5) Connect battery on E010 and immediately pull down the throttle stick. It should bind. If throttle stick is at maximum and pulling down it may not bind (too long time). It looks time interval to bind after connection a battery on E010 it is very short and critical. At least this way to bind worked for me. P.s: also my Devo 7E with mods binds to: Syma X5c, DFD F183, and Xieda 9968 (for this one need to learn how to adjust mixers to make it to hover and fly properly).
Many thanks to goebish for his hard work as well as help from other members contributing to a forums.