Eachine E010 inductrix clone data captures

hi, i know i'm a LOT late, but i am unable to bind my jumper t8sg v3 plus to my e010. i have tried:
using mjqx > e010
using eo10 (various frequency adjustments)
doing a LOT of googling (1.5 hr)
adjusting channel mapping
adjusting channel numbers

any advice, thanks

Hi, I tested with Jumper T8SG v2 plus and E11 with these settings:
Model type = Multi
Tx Power = 3mW (for use indoor)
Protocol = Bayang, Format = Regular, Telemetry = off
FixedID = 123456
Chanells = 12

Mixer:
1-Ail Simple AIL
2-Ele Simple ELE
3-THR Simple THR
4-RUD Simple RUD
This works for me with T8SG v2 plus and Eachine E11.

Below are my settings for T8SG v2 plus I used for E10:
Model type = Multi
Tx Power = 30mW
Protocol = MJXq, Format = E010
FixedID = 123456
Chanells = 12

Mixer:
1-Ail Simple AIL
2-Ele Simple ELE
3-THR Simple THR
4-RUD Simple RUD

The settings above for E010 worked for me too (can't test now, don't have E010 anymore).
I hope this gives an idea. Also check my post number 74188 in this thread.

I have the same issue. I bought the T8SG V3 Plus (Carbon edition) because I thought it would bind with the E010. I contacted Jumper and they said that it only works with the green PCB version of the Eachines E010.

This is a huge bummer

I have eachine e010 with red board. I want to bind it with my flysky fsi6x via homemade arduino multiprotocol tx. Where can I find the protocol code for eachine e010 red board?

HirusFPV wrote: I have eachine e010 with red board. I want to bind it with my flysky fsi6x via homemade arduino multiprotocol tx. Where can I find the protocol code for eachine e010 red board?