CX 10D Traces

I got a new CX 10D and it does not seem to work if any of my protocols of the DIY Multi module but maybe I did not check hard enough.

Anyway, I captured SPI traces from its remote but haven't had time to look into them yet. So here they are, perhaps someone else will find them useless.

The remote has small daughterboard with the rf chip. I cannot see the markings since the oscilator is glued on the chip :/

Files are here: gist.github.com/schwabe/9e8563f1abecbee4660763e798e4ee78

I got a CX-10WD, the variant with wifi fpv. The transmitter uses a XN297L. I can make captures if you think it helps.

See capture here
Not sure if it is same as CX-10D.
I can also capture another CX-10WD if needed but not tonight. I have to solder on the MCU's pins which makes my eyes ache.

Let me know if you need captures of another CX10WD transmitter.

I just received my CX-10D (no cam, just baro).
I also own a logic analyzer and know how to use it.
Does it make sense to make some captures?

Alright! Will do it when I get up!
Thanks

OK, I uploaded my first set of captures.
Sent you a PM goebish, don't want links to my private server out in the open.
But anyone who wants to see them can have the link - just reply / PM me please!

After closing down the remote again, I took some time to fly the CX-10D…
I must say that it isn't half bad at all!
The auto-height feature is somewhat not super-fine in terms of navigation, but kinda steady.
Auto-take-off is fun, the manual version is not always successful, especially when the battery is going low.
Auto-landing seems to be "going a bit down, checking gyro if there was a surface, doing it some more times to be sure, then turn off motors"
Crashing this thing is kinda different to other copters, it seems to detect crashes / blocking motors fast and then turns off all motors. Of cause that is needed, because there is no manual throttle, you always just tell it "up" or "down".

The 3 rate-settings are quite good, 1 is nice and slow, 3 is quick plus fast, yet precise spinning.

I modded the 10D in that I cut out the front & back of the battery-compartment, desoldered the stock-battery and added a cable with socket, so that I can switch out batteries with my other 150mA models.
Problem is that there is no forward / backward trim (those are start/land), so you have to balance the battery out.

I wonder how precise it will fly once it's deviated…

Sorry I should have deleted them as I thought they were of no use. I shall redo it again and repost a new link.

CX10WD binding capture is re-uploaded here

I wonder if there is a code for trimming front/back, since that button does take-off/landing on the CX-10D.
would be handy for sure…