Protocol telemetry question

Hi guys, I finally got a devo 7e , and coded some telemetry for the bayang protocol.

One problem I need some help with is, the main page config won't save the telemetry box I set after a powerdown, and the telemetry config page also won't save.

So far I only modified the bayang protocol code. So the question is, how do I make the devo save the main page telemetry related settings?

That would be awesome, we can setup a lipo and range alarm. In the past can remember have seen some requests for telemetry modification for Bayang protocol here on the forum.

Anyway, can't help you with your question but likely some of the active coders using telemetry fields like f.i. Hexfet, might be able to answer you?

the frontpage and telemetry settings should save no problem as the settings are stored in each model*.ini file, for instance here's some of the ini contents that show where the telemetry settings are kept

if your 7e isn't storing changes perhaps the voltage of the tx's batteries are too low, or there is some issue with the power down saving. first try changing the telemetry and frontpage settings you want, then go into the model menu and load a completely different model, once that's done then load the model you made the changes to again and see if the changes stuck, as the model*.ini is also saved when you load a different model. btw is that you from rcg silverxxx?

Thank you for your reply.

I checked the model file, and it looks like it's saved after the first power off, but it disappears after a second time. So I guess it gets deleted perhaps because it might think the protocol has no telemetry?

The saving works fine on a protocol like DSM, so the saving part works when it comes to telemetry for that protocol.