jjrc h36 mjxq e010 protocol bind problems

Hey guys, I was trying to get my jjrc H36 to bind and fly correctly for a couple of days on my devo 10 and devo 7 modded with the 3 in 1 of course. Heres my experience, when the tx power is above 30mW on the devo 10, the jjrc H36 will not be bound and if it is bound it will have a huge delay in stick inputs. On my devo 7 when the tx power is above 1mW you get the same problem. I dont mind flying this at low tx power since it is an indoor flier but for anyone else having problems then I hope this helps. Oh and one last thing, this protocol doesnt bind to the jjrc h36 on the taranis with the 4 in 1 module installed. I guess its because of the same issue.

I have a Devo 7E modified for me with all the bells and whilstes Deviation has to offer.
I cannot get it to bind to the JJRC H36 using thebMJXQ format, EO10 format option either.

I notee that looking through the supported models list the H36 is not recorded in the list of JJRC supported models, presumably the above format/option is a discovery as a result of the E010 discovery.

Can anyone tell me if they have had similar problems and how they managed to resolve them, if at all please?

Sorted it ot, I turned down the power setting and it could bind

Just a little more info to add to the mix here.

I have just bought in two H36's from Gearbest. One is the blue version, the other the grey version.

The blue one will bind to my Ultimate7E with a 3-in-1 module no problem (MJXq/E010 protocol) - no matter what power setting - and it really does fly very well, even though I have only tried it 'as is' with no tuning on the TX at all!
The grey one will not bind at all. I have tried power settings up to 30mW and no different. Simply will not bind.

The odd thing is I can swap the supplied controllers - bind the grey controller to the blue H36 and bind the blue controller to the grey H36!

I can see no logical reason why the Devo will not bind to the grey H36, but something is preventing it. A very minor difference somewhere in the protocol/handshake that the supplied controllers are ignoring?

Unfortunately I do not have a scope to see what, if anything is different. I rally must get one!

This may be of some help to anyone that has a grey H36 that will not bind.

I am having a very similar problem.

I received a new JJRC H36 yesterday and it will not bind to my Jumper T8SG wheras my Eachine 010 binds and fly's fine. And, similar to your problem, the H36 binds and fly's perfectly with the original Eachine 010's TX. Did you get your H36 sorted out?.

Thanks. I tried all different power settings. No joy unfortunately. I will probably sell the JJRC and buy another Eachine and just have to wait for ages for it.

I bought another Eachine 010 and guess what? The new one will also not bind. They have obviously changed something.