VISUO XS809H-W-HD-G (Bayang X16 AH) capture

haha small world jay. bro, please share with me the visuo/jumper secret. what is the price???bless

no tricks bound right up - fire motor button or channel is way way down the list all other functions seem to be working as well

how do jay drone do itt. please make a video please

Using the Bayang X16 AH - Not sure if anyone posted this, but you need to enable Channel 11 with the switch of your choice (I like G since I use that on all my drones). Then, if already bound and ready to fly, you flip that switch and quickly take off manually with throttle. The motors will start and you can take control, but if you don't take off pretty quickly, they just stop after a few seconds. Perhaps there is a smarter way, but I was just happy I could fly with it.

Not sure what the other channels are doing, but I've enabled them and have not tested them fully.

I just found my 809hw board and it bound right up to the bayang X16 protocol on my Jumper T12.

hmmm.. I have an xs809s that needs a new motor anyway.... if I swapped boards assuming the camera module works with the hw board I'd have a nice 15+ minutes of flight time. Yet my soldering skills are pre-school level as I age...

#firstworldproblems imna punk out and buy one what I ain't crashed to pieces yet

no luck on the sticks down and in to arm?

Only asking because that is how I got my cx10wd to take off when all I had was bind and four..

so the bayang x16 after all the updates due to bugs seems the it has messed up something the drone will bind but the channels must be messed up idk - i was able to switch stuff around and get motors to fire but not to have drone lift - any assistance would be great -