R9M protocol on deviation

More
14 May 2018 03:17 - 14 May 2018 03:18 #69205 by anthony
R9M protocol on deviation was created by anthony
hello Developers

any idea about protocol R9M on multiprtocol Deviation ?, I see RX mini is so cheap , about 9 $ but modul is not cheap .So will great if multiprotocol add R9M into system

and modul SX1276 100mw or 1w is so cheap on market
Last edit: 14 May 2018 03:18 by anthony.

Please Log in or Create an account to join the conversation.

More
14 May 2018 05:58 #69210 by vlad_vy
Replied by vlad_vy on topic R9M protocol on deviation
FrSky R9 and R9M use 900MHz and different hardware, so it's impossible.

Please Log in or Create an account to join the conversation.

More
14 May 2018 06:58 #69212 by ajtank
Replied by ajtank on topic R9M protocol on deviation
Perhaps he is suggesting to piggyback a SX1276 module onto existing multimodule. Connection involves voltage supply, SPI bus and RF switch control.

Please Log in or Create an account to join the conversation.

More
14 May 2018 07:49 - 14 May 2018 07:50 #69213 by Fernandez
Replied by Fernandez on topic R9M protocol on deviation
There is a topic op on this, there are now several systems using the Semtech modules, which have now been proven themselves......
-TBS crossfire
-Frsky L9
-In addition there are diy projects as Qlrs, and some more



www.deviationtx.com/forum/7-development/...-sx1278-sx1276#68370
Last edit: 14 May 2018 07:50 by Fernandez.

Please Log in or Create an account to join the conversation.

More
15 May 2018 01:23 #69225 by anthony
Replied by anthony on topic R9M protocol on deviation

Fernandez wrote: There is a topic op on this, there are now several systems using the Semtech modules, which have now been proven themselves......
-TBS crossfire
-Frsky L9
-In addition there are diy projects as Qlrs, and some more



www.deviationtx.com/forum/7-development/...-sx1278-sx1276#68370

when frsky publish RX mini SMALL AND CHEAP , i forget system QLRS.

Please Log in or Create an account to join the conversation.

Time to create page: 0.038 seconds
Powered by Kunena Forum