Devo 10: Curves on mixers of complex output

Hi,
I'm unable to setup Curves on the second mixer of a complex output?

Here is my setup
GEAR => Complex (2 mixers)
* Page 1:
-Switch : None
-Mux : replace
-Src: Virt1
-Curve : 1-to-1 (but I can setup a 3 Point curve, this one is OK)
-Scale : 100
-Offset : 0
- Trim (trim of Virt1 is set on TRIM_L)
* Page 2:
-Switch : None
-Mux : add
-Src : GEAR
-Curve : 3point (But unable to ENT to setup this curve which is fixe on 0?)
-Scale : 100
-Offset : 0
-No Trim

As I do not manipulate well complex output I'n not sure that it's a bug.
If it is normal could you please explain me why?
Thanks

PhracturedBlue wrote: Yep it is a bug which I introduced today when I fixed another one.
I've committed a fix.
Thanks.

I don't see your fix yet so I fix it in my repo. the following statement should be changed to ">="
if (mix->curve.type == CURVE_EXPO