Temperature reading not working

Hello,
first of all congratulations for v2 software, it's fantastic, it has everything you can need.
then a simple question:
I just upgraded devo6s with v2.0 but I have a little problem:
with 2 rxes, minicp and v120d02snew, having both temp sensors connected,
the temperature displays "----" while rx voltage is corretly displayed.
With original fw it worked correctly.

Any help ?

Thanks again.

Try upgrade with attached dfu, it should work.

Note that in this latest version, telemetry is turned off by default, you need to turn it on in the model setup page by pressing the Devo button

suvsuv wrote: Try upgrade with attached dfu, it should work.

Note that in this latest version, telemetry is turned off by default, you need to turn it on in the model setup page by pressing the Devo button

Thank you, but I have devo 6, the file attached seems to be for devo 8.

dado099 wrote:

suvsuv wrote: Try upgrade with attached dfu, it should work.

Note that in this latest version, telemetry is turned off by default, you need to turn it on in the model setup page by pressing the Devo button

Thank you, but I have devo 6, the file attached seems to be for devo 8.

Then try this one instead

suvsuv wrote: Then try this one instead

Thank you suvsuv, I've just tried, but it doesn't work either.
The curious thing is that if I set a low alarm value on Temp1 it works correctly (beeps) and correctly stops beeping if I unplug the sensor.
So it seems it reads correctly, but no display !