New Gaui X5 with BeastX and AR6210 +Deviation 3.0

On a Devo 8s.
Is the setup a safe combination? I've been flying a 450 pro with a walkera receiver with great success previously I. v2.1.

Is the Deviation v3.0 stable using DSMX and the AR6210 and one dsmx satellite? Any tips? Anything I should think about or do?

Thank you very much in advance!
Best regards,
Tom

Do any one know?

Not quite the same I know, but I'm running the devo 8s on deviation 3.0 with an AR7200bx on a 450pro with no problems at all, just need to remember to allocate the tail gyro to the gear channel..

Fishfiend wrote: Not quite the same I know, but I'm running the devo 8s on deviation 3.0 with an AR7200bx on a 450pro with no problems at all, just need to remember to allocate the tail gyro to the gear channel..

Great! Approximately, how many flights have you had on the setup?

togy wrote:

Fishfiend wrote: Not quite the same I know, but I'm running the devo 8s on deviation 3.0 with an AR7200bx on a 450pro with no problems at all, just need to remember to allocate the tail gyro to the gear channel..

Great! Approximately, how many flights have you had on the setup?

I only set it up 2 weeks ago..But I've had about 15 flights with no problems, I've even flown(hovered) my mates Goblin 700 by binding to it the ar7200bx on it. Full control just make sure when you bind you use 8ch not 7ch,. Smart safe is set when first binding with the throttle channel all the way down.. It works great.

vlad_vy wrote:

togy wrote: On a Devo 8s.
Is the Deviation v3.0 stable using DSMX and the AR6210 and one dsmx satellite? Any tips? Anything I should think about or do?

Thank you very much in advance!
Best regards,
Tom

I think AR6210 has full failsafe (Preset Failsafe) on throttle channel only. All other channels hold last position (SmartSafe). If it's not a problem for you, all other have to be OK.

Ok, thank you for the information. That's actually what I prefer! My concern is if I will have a steady radio link with out glitches. A year ago running walkera firmware I had numerous glitches that caused some crashes. So my main question is: is Deviation 3.0 DSMX stable and reliable?

vlad_vy wrote: I haven't any problems with v3.0 and DSMX.

Ok then I'll be running it on my new X5 that comes with the post today:-)