F12E RX1002 CC3D OK except no failsafe

Start
Prev
1
Next
End

jayessell
Topic Author
Offline

04 Jun 2015 21:33 #33436 by jayessell

F12E RX1002 CC3D OK except no failsafe was created by jayessell

Howdy!
I have the Devo F12E and wanted the QAV250 I'm building to be compatible.
The frame/motors/ESCs/Flight controller kit I got uses the CC3D.
I purchased a RX1002 thinking I'd add features later and might need the extra channels.
Also... I thought I was tied to DSSS to use the F12E.
Binding OK!
All ok so far says OpenPilot... except... the connection doesn't go to FALSE when I turn off the transmitter. This means no emergency cutoff available. (GPS RTH coming later.)

Can't fly like that!

I see others have had this problem and resolved it.
Details please!

Please Log in or Create an account to join the conversation.

FDR
Offline

05 Jun 2015 04:10 #33454 by FDR

Replied by FDR on topic F12E RX1002 CC3D OK except no failsafe

DEVO receivers all have the failsafe feature.
You can set a separate failsafe value for any channel on the channel config page...

Please Log in or Create an account to join the conversation.

vlad_vy
Offline

05 Jun 2015 05:26 #33457 by vlad_vy

Replied by vlad_vy on topic F12E RX1002 CC3D OK except no failsafe

If you use original Walkera firmware, you need setup failsafe in 'Fail Safe' menu. Select 'Fail Safe' option for channel and setup desired failsafe value.

Please Log in or Create an account to join the conversation.

jayessell
Topic Author
Offline

05 Jun 2015 11:10 #33463 by jayessell

Replied by jayessell on topic F12E RX1002 CC3D OK except no failsafe

When you say 'Walkera Firmware', what do you mean? In what device? The receiver? How do I access that? 'Select Failsafe' in what application? Open Pilot?

I did say I needed details.

Thanks!

Please Log in or Create an account to join the conversation.

PhracturedBlue
Offline

05 Jun 2015 13:17 - 05 Jun 2015 13:18 #33468 by PhracturedBlue

Replied by PhracturedBlue on topic F12E RX1002 CC3D OK except no failsafe

First off, this forum is all about the 'Deviation' firmware. It is a replacement for Walkera's firmware on the transmitter to give the Tx more capabilities. It is in no way associated with Walkera.

FDR and vlad are talking about the transmitter. On a stock transmitter (one running Walkera's software and not Deviation), in the transmitter menu there is a fail-safe option (see page 44 of the F12E manual)

You don't need to do anything to the receiver

Last edit: 05 Jun 2015 13:18 by PhracturedBlue.

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Time to create page: 0.042 seconds

Re-enable mobile display