DJI ocusync and Deviation (Devo10)

Hello @all,

the new Ocusync from DJI is a nice system for Racers and it should be compatible with the Devo10 - so i thought. My devo is of course running Deviation, so it is not recognized by the DJI Goggles RE. I figured it is probably a setting of the PPM output via DSC.

Can anybody tell me, what the original Output Data of the Devo10 is? Or what settings I should choose to mimic a standard Devo10?

Thanks in advance!

With deviation set the protocol to PPM in the model. You're correct the PPM output is on the trainer port on the tx.

Thank you, but I did that. The Goggles just give an error, that this 3rd Brand remote is not supported.

I figured, that the output format is maybe not the same as original firmware, but as the output can be adjusted, maybe I can mimic the original firmware output?

Don't know what the original firmware PPM output looks like. Deviation shouldn't be much different as the timing is pretty standard. Maybe the number of enabled channels is different? Does DJI give any info on the acceptable PPM signal? Is it a known good cable to the goggles?

It is the cable, DJI provides. Unfortunately, there is no good documentation of the hardware or software by dji.

OpenTX seems to work out of the box. Maybe I'll look up if I can find the standards there.

I'll also check the number of channels later. Could do the trick.