Bugs 3 binds to Jumper T8SG throttle not working

I applied firmware update to Jumper T8SG to support working with Bugs 3. The Bugs 3 does bind with it but the craft does not respond to throttle input.

Symptoms:
Craft binds and all motor spin up IF throttle it set to midpoint(centered). All motors continue to spin until I drop throttle below midpoint then the motors will stop within a few seconds.
When I increase throttle nothing happens the motor continue to spin at the same RPM.

I have calibrated the sticks several times with no luck

Appreciate any advice I can get resolving this issue.

What does the Channel Monitor screen show?
Is the throttle channel transitioning -100 to +100 correctly?
Maybe post the .ini file for us to look at.

Yes - The throttle channel positioning is correct -100(min) > 100(max).
I attached the bugs3 model configuration file

hello! I have the same problem after following JayDrone's video with the bugs3mini proto which is on my standard Jumper T8G (bought it this month). I loaded in your model too onto my radio and still no throttle or stick output