Devo 12s switch problem

Start
Prev
1
Next
End

ferreret
Topic Author
Offline

24 Jan 2019 08:29 #72513 by ferreret

Devo 12s switch problem was created by ferreret

Hello! I'm programing my devo 12s with deviation 5.0.0 to use with a DJI dron. I need to assign two channels with a potentiometer switch, but after many tests all the times the potentiometer runs likes a two position switch(only on-off). If I asign this aux channel with an stick(elevator), then runs perfect with progressive position. Any idea why I can't run this switch like a progressive switch?

Thank you for advanced

Please Log in or Create an account to join the conversation.

vlad_vy
Offline

24 Jan 2019 09:46 - 24 Jan 2019 09:56 #72515 by vlad_vy

Replied by vlad_vy on topic Devo 12s switch problem

Any analog input can be used as "Src" for channel mixer.

Also, are you sure that you calibrate AUX pots along with sticks?

Last edit: 24 Jan 2019 09:56 by vlad_vy.

Please Log in or Create an account to join the conversation.

Gerry
Offline
Bbrad

24 Jan 2019 10:57 #72516 by Gerry

Replied by Gerry on topic Devo 12s switch problem

have you tried calibrating the tx including pots?

Devo 7e A7105 NRF24L01 CC2500 2x3 way & voice, Devo 12e 4 in 1 & voice.
FFS (Forever Fixing Stuff)

Please Log in or Create an account to join the conversation.

ferreret
Topic Author
Offline

24 Jan 2019 18:06 #72518 by ferreret

Replied by ferreret on topic Devo 12s switch problem

Thank you very much for yours answers!

Please Log in or Create an account to join the conversation.

ferreret
Topic Author
Offline

25 Jan 2019 21:35 #72529 by ferreret

Replied by ferreret on topic Devo 12s switch problem

You are right, after calibrating the rudders runs perfect!

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Time to create page: 0.112 seconds

Re-enable mobile display