need help please!!

i tried to upload the deviation fw and it wont upload and now when i try to turn off my tx the screen blinks...it erased the devo firmware but failed to upload the deviation...i tried to reinstall the devo fw but it it says unable to find data for the device...

what did i do wrong?

the screen just flashes with the current picture it had...

i managed to get the devo firmware to reinstall but when i left DFU mode the screen looked all funky so i am trying to put the library back to see if it straightens it out...after several attempts i did get back to the upgrade screen...

after reinstalling the library i was using the screen still looks all funky i can see the model and timer ect...but the background is just a bunch of scribbles and pixals...

do i install the deviation library first then the firmware? or does it matter which is installed first?

woohoo i got it!! i installed the library first then the firmware and it is now working...

thanks a bunch!! im sure i will have many other questions and i can't thank you guys enough for all your work and help..

if i had a fixed ID on a model in the devo firmware will i need to clear it before the Deviation will bind to it?

oops...i guess i should have wrote that down when i created it.Oh well i'll just clear it out and redo it..will the wk2801 rx's that wont use fixed ID with the 2801pro use fixed ID with the deviation fw?


thanks.

it seems to be working nicely, i havent tried to bind it with anything yet but i will shortly...i been going through the menu ect and looking it over and all looks great!

i can't seem to figure out how to set the switches..i want to use the mix switch as the gyro sensitivity but haven't figured out to do it..also if i set the stick mode to 3 does it automatically reassign the channels? i don't want to bind it to a heli and have it go to half throttle all of a sudden..

had no problems getting it to bind to my 2801 heli's but i can't for the life of me figure out how to get it set up correctly..i followed the manual for setting up a heli and no luck getting the collective pitch to work correctly ..the channel moniture screen shows the correct outputs but the servos are not moving like they should...it shows 3 out puts on the screen but only 2 servos move when i move the throttle stick...if i select none on swash type i get the rite movements for aileron and elevator but unless i select 120 for the swash i got no collective pitch at all..

update: i managed to get the cyclic working pretty close but still need to do some tweaking...i had to set ele to cyclic 2 and ail to cyclic 1 ...

now for the big question does anybody know how to setup the gyro sensitivity ?
its usually set to the mix switch giving 3 different gyro settings but i can't figure how to get it to work as of know i have no tail gyro avtivity at all when i move the tail back n forth which means the gyro is not working ...



thanks all..

thanks, i will try your suggestion on using a virtual channel and see if i can find out which channel the gyro uses..soon as i get it working i will share the file ..