x4r-sb not bindin devo 7e

Hello,
the Wire job is not to bad. 7 to 9 is the Pa enable, may be here a little error ( pad looks a bit burned with solder iron)
i can report mid of the week, i have bought a X4r sb for me to Test on the 8s. May be i solder a cc2500 into my 7e to verify the Build with it.

i report then

greetings Alex

Hello, X4R SB with newest non EU does Bind with my 8S and Telemetry works with out any Problem.
On Weekend a new 7e is coming ( i do not want to rip my 7e with 3 Modules apart, so i ordert a new one )
I report then with the new TX on Weekend or next Week.

greetings Alex

Thanks Alex. I appreciate it.
I'll ask the seller if he may have shipped it with eu firmware.
I'm going to have to find someone with a taranis and bind it to theirs haha. Only thing i can think of right now

Hello,

i have my New 7e ready with the cc2500 and the latest FrskyX Test Build Ver. d76
The Bind and Servos are working with the X4rSB ( Last non EU updated by me with the Sport to USB Update Tool)
my last Tip for You, do You have the Channel Number set to 12 bevor Bind ?
if the green LED does Blink fast after Bind then it is ready connected and Channel 3 is Throttle ( to test with Servo )

i hope it helps
greetings Alex

I just bound with absolutely no issue to an X4R-SB non-EU. Either you have a bad receiver, or it's not non-EU.

Thanks for all the updates guys. Will ask the seller whether the receiver is non-eu. Will also try and find other frsky stuff to bind to.
I have a feeling that the cc2500 is dead/bad. What do you guys think ?

Hello,
some one had a similar Problem with his CC2500, but it was the other one ( at the list of the wire Info Page ).
The Module was working normal but after some Time it was going bad.
Do you have a other RX or flyer who need the CC2500 ? then you can test the TX Module ( the only difference is the Software Protocol )
I have 2 of the blue CC2500 , 2 X 7105 and all are ok.

May be yours is damaged , changing it is the cheapest way. The next is the USB Dongle from Frsky with updating the Firmware.
If your seller is outside EU then the RX should a non EU Version.
If You need more Info for buying the right Dongle, Firmware Version, Handling for Updating then ask, i try to help !

greetings Alex

Thanks for helping everyone.
My x4r just died today It doesn't turn on anymore.
I think it might have been a problem with it from day 1
I'm going to get a replacement and report back
Edit: I forgot to mention that it did NOT bind to a taranis plus.

It could be a bad module. I experienced the same.
As X series need a very precise crystal to perform manual calibration so I suspected that's the bad module.
Can you try a D8? It use automatic calibration and may work