NRF24L01 problem Help!!

I have installed the module and took extra care to make sure all connections were properly soldered and nothing was touching, however in my excitement to test it I forgot to attach the antenna I powered it for about 30 Seco do before realizing it and quickly turned off the controller and plugged in the antenna. When I turn on the controller now it says the module is missing and I fear I have blown it. Did I, am I know looking at getting a new one?

Post your hardware.ini file that is currently on your Tx.

;Only useful for transmitters with an after-market vibration motor
;enable-haptic=1
;
;switch_types: 3x2, 3x1, 2x2
;extra-switches=
;
;button_types: trim-all, trim-(left|right)-(up|down|both)
;May occur more than once if necessary.
;extra-buttons=
;
[modules]
; there is no need to enable the cyrf6936 module unless
; it is wired to an alternate port. It is Enabled automatically otherwise
; enable-cyrf6936 = B12
has_pa-cyrf6936 = 0
; enable-a7105 = A13
; has_pa-a7105 = 1
; enable-cc2500 = A14
; has_pa-cc2500 = 1
enable-nrf24l01 = A13
; has_pa-nrf24l01 = 1
; enable-multimod = A13

What firmware are you running?
High rez pictures of your wiring and soldering job would also be helpful.

For the hardware.ini:
Add a ; in front of the CYRF line.
If your nRF transceiver has +PA +LNA, remove semicolon from the has_pa-nrf24l01 = 1 line

******************
;Only useful for transmitters with an after-market vibration motor
;enable-haptic=1
;
;switch_types: 3x2, 3x1, 2x2
;extra-switches=
;
;button_types: trim-all, trim-(left|right)-(up|down|both)
;May occur more than once if necessary.
;extra-buttons=
;
[modules]
; there is no need to enable the cyrf6936 module unless
; it is wired to an alternate port. It is Enabled automatically otherwise
; enable-cyrf6936 = B12
; has_pa-cyrf6936 = 0
; enable-a7105 = A13
; has_pa-a7105 = 1
; enable-cc2500 = A14
; has_pa-cc2500 = 1
enable-nrf24l01 = A13
has_pa-nrf24l01 = 1
; enable-multimod = A13
******************