can't save models any more...

have a devo 10 running deviation 5.0 saved 3 models but now can't seem to save any more. can some one talk me through the process please.

Your batteries arn't to low are they?

Setup model
SWITCH MODEL FILES
Power off tx.
Check if it saved the new one

I also had this problem. The problem was I was using a 2s life battery which was far too low in voltage so the tx would power on but I couldn't save anything.

This is what I wrote in another thread about not being able to save when using a 2S lipo:


You need to edit tx.ini, and set batt_critical to a lower value.
I think the default is about 10500 (mV).
Set it to the lower limits of a 2-cell pack, say 7500 (7.5 V), and you should be fine.
batt_critical can not be edited in the tx gui, you have to do it from a computer over USB.
Do not edit with Notepad, use Notepad++ or some other proper editor.