- Posts: 8
Binding FrSky RX impossible
- dnlpr
- Topic Author
- Offline
Less
More
12 Jul 2018 14:23 #69860
by dnlpr
Binding FrSky RX impossible was created by dnlpr
Hello,
I have 2 receivers FrSky, X8R and G-RX8, already used with a taranis QX7, I want to use them with my T8SG Plus, but the binding does not work, is there a special procedure for FrSky?
Thank you for any answer that can help me.
I have 2 receivers FrSky, X8R and G-RX8, already used with a taranis QX7, I want to use them with my T8SG Plus, but the binding does not work, is there a special procedure for FrSky?
Thank you for any answer that can help me.
Please Log in or Create an account to join the conversation.
- Ask1me
- Offline
Less
More
- Posts: 11
13 Jul 2018 17:19 #69872
by Ask1me
Replied by Ask1me on topic Binding FrSky RX impossible
same problem here with jumper t8sg v2+
Please Log in or Create an account to join the conversation.
- hexfet
- Away
Less
More
- Posts: 1892
13 Jul 2018 18:10 #69873
by hexfet
Replied by hexfet on topic Binding FrSky RX impossible
For these receivers the deviation protocol to use is FrskyX.
Try binding with the Freq-Fine protocol option set from -127 to +127 in steps of 10.
Bind by powering on the receiver with the F/S button held down, then activate Bind in deviation model setup.
After binding move Freq-Fine up and down to find the max and min values where bind is lost. Leave it set to a value halfway between min and max.
Try binding with the Freq-Fine protocol option set from -127 to +127 in steps of 10.
Bind by powering on the receiver with the F/S button held down, then activate Bind in deviation model setup.
After binding move Freq-Fine up and down to find the max and min values where bind is lost. Leave it set to a value halfway between min and max.
Please Log in or Create an account to join the conversation.
- dnlpr
- Topic Author
- Offline
Less
More
- Posts: 8
14 Jul 2018 07:48 #69876
by dnlpr
Replied by dnlpr on topic Binding FrSky RX impossible
A big thank you for your answer.
Silly question, I am a beginner with JUMPER, could you tell me how to get Freq-Fine protocol option set?
Thank you
Silly question, I am a beginner with JUMPER, could you tell me how to get Freq-Fine protocol option set?
Thank you
Please Log in or Create an account to join the conversation.
- hexfet
- Away
Less
More
- Posts: 1892
14 Jul 2018 12:16 #69877
by hexfet
Replied by hexfet on topic Binding FrSky RX impossible
To get to protocol options go to the Model setup page, select the protocol button, and press ENT.
Please Log in or Create an account to join the conversation.
- dnlpr
- Topic Author
- Offline
Less
More
- Posts: 8
16 Jul 2018 06:08 #69884
by dnlpr
Replied by dnlpr on topic Binding FrSky RX impossible
Hello, it works! thank you very much for your help.
Please Log in or Create an account to join the conversation.
Time to create page: 0.041 seconds
- Home
- Forum
- General
- General Discussions
- Binding FrSky RX impossible