HOTEN X voltage sensor issue

Would anyone know why I am getting the low voltage alarm on my devo 10 with my Hoten X regardles of how low I set the alarm voltage. The last time I used my Hoten was a few years ago but it worked just fine then. Voltage is set to 7.2 Transmitter is running devention firmware

Voltage of battery reads 8.3 in sensor view but still getting alarm.

I have changed nothing. Also seem to have same issue with the ladybird whichnis set to 3.6

Thanks to anyone that can help. I do have other devo 10 transmitters, some with devention and some with deviation. Have not tried moving the model file to a different transmiiter with devention or setting it up on one running deviation.

Could be that your batteries sag badly under load if they are getting old.
Also I found that using voltage telemetry with my ladybird or super cp would significantly reduce flight times.

Thanks for the reply. Batteries are all new and alarm sounds even with fully charged batteries without the motors running. Since this happens with both my hoten x and both ladybirds I have to assume its a transmitter issue. I have other Devo 10s i can transfer model files too. Just haven't gotten around to it yet.

thanks you!

websiite: teeshirt24h.comteeshirt24h.com