hey there,
I installed a cc2500pa into my devo 7e and liked it so much I decided to add a NRF24L01 for my v922. I cut the wires at the mid point coming off of the cc2500pa, and then just spliced the nrf24l01 into the existing wiring. Im worried I may have fried the board, because I mixed up the CSN and CE pins. so I had the CSN going into the VCC pin on the transmitter, and I had the CE pin running into the TCK pin. I caught it after only turning on the transmitter once, but once is all it would take, so thats been a concern for me. Could this mistake fry the board? or perhaps the TCK pin? Anyways I corrected the wiring, then 'enabled nrf24l01=A14' (since its going into my TCK pin) then i changed the power from '=0' to '=1'
I then turned on my TX and went to a v922 model I had currently set up to work with the WL-T6 external adapter, and changed the protocol from 'ppm' to 'HiSKY' and tried to bind my heli with no luck.
WHAT AM I MISSING?!?!
The thing is my cc2500 module is working, so I really think the wiring is all solid. I even cut the wires and spliced it again, making sure ever thing was wired in perfectly.
any help would be appreciated.
