Looking for Buddy box config for Master CP/Devo7E

Hi
Does anyone have buddy box config files for a master cp and 2 Devo 7E's ?
Well, as long as its for a walkera heli i could change the rest.

Unless it was added to the latest version of deviation, buddyboxing is not supported.

Not sure when PPM made it in, but you can buddybox with the nightlies.

It was implemented after 3.0.0 was released, but works as a charm in the nigthlies.

rbe2012 wrote: It was implemented after 3.0.0 was released, but works as a charm in the nigthlies.

Really? thats great!

SO what do I need to do to get it to work? is there a step by step somewhere? I just put 3.0 on my 8s but I'm not clear on how nightlys work?

rbe2012 wrote: On the trainee's tx you set the protocol to PPM out, on the trainer's tx you set PPM in to "Channel", assign the channels (1:1 if you use the same model.ini) and define a trainer switch (don't know which way it works: active means trainee or trainer has control?).
There is another thread about PPM input where you can find further information: www.deviationtx.com/forum/7-development/...gram?start=100#10845

Please look here: http://www.deviationtx.com/forum/6-general-discussions/2114-how-to-setup-double-command#13150 .

rbe2012 wrote:

rbe2012 wrote: On the trainee's tx you set the protocol to PPM out, on the trainer's tx you set PPM in to "Channel", assign the channels (1:1 if you use the same model.ini) and define a trainer switch (don't know which way it works: active means trainee or trainer has control?).
There is another thread about PPM input where you can find further information: www.deviationtx.com/forum/7-development/...gram?start=100#10845

Please look here: http://www.deviationtx.com/forum/6-general-discussions/2114-how-to-setup-double-command#13150 .

Thanks for the link, I posted a question about it in the thread you linked.