HOLD Super CP

Start
Prev
1
Next
End

Neposeda_ua
Topic Author
Offline

10 Oct 2013 08:03 #14417 by Neposeda_ua

HOLD Super CP was created by Neposeda_ua

How to setup HOLD to stop the motor and servo shifted to neutral (middle) position.
I can not make out with a HOLD on the new menu firmware ((

Please Log in or Create an account to join the conversation.

RoGuE_StreaK
Offline

10 Oct 2013 09:38 #14423 by RoGuE_StreaK

Replied by RoGuE_StreaK on topic HOLD Super CP

Go into each Channel and set the Safety. Set the button it responds to and what value it should go to when engaged.

Please Log in or Create an account to join the conversation.

svoy
Offline

10 Oct 2013 16:39 #14464 by svoy

Replied by svoy on topic HOLD Super CP

Excruciates by such question firmware version Deviation 3.0.0. Where that have read that in it have the opportunity set the counter total flying model. Can someone tell me how to do this?

Please Log in or Create an account to join the conversation.

rbe2012
Offline
So much to do, so little time...

10 Oct 2013 16:45 #14467 by rbe2012

Replied by rbe2012 on topic HOLD Super CP

On timer page define a timer as a "permanent timer" and associate a switch to it. The values are stored and the timer will start at the last position when you reload the model.

Please Log in or Create an account to join the conversation.

Start
Prev
1
Next
End

Time to create page: 0.032 seconds