HiSky HCP100S with nRF soldered

FMODE 0/1/2 = Throttle LOW/MEDIUM/HIGH (always the same pitch curve, no normal mode)

RUDD DR0 Throttle HOLD

AILE DR1 reset timer



For Devo10

No time for a full test, but my bird binds and hovering perfect. Thanks a lot.

I just deleted the previous setting and put a new file. The olny difference is a better pitch limit. There was too much pitch. The timer is now set at 5 minutes but it can hold even more time on the original lipo.

Has there been any new development for the Hisky protocol to support the HCP100S? Is the HCP100s supported for 7 channels or 6 channels?

joeclone wrote: Has there been any new development for the Hisky protocol to support the HCP100S? Is the HCP100s supported for 7 channels or 6 channels?

This is for nRf soldered