Xinxun X39 config

I slapped a x39 xinxun board on a 120mm frame with 8.5mm motors.

It is flying great after a bit of playing however...

it will randomly do a high speed flip if I do a high speed run and try to slow down to a hover... only some times.

also the yaw is slow but no adjustment seems to effect it.

has anyone had any luck with this yd /xinxun protocol and setting this up well?

edit - I need to figure out where the rates and flip is more specifically.

Hello dude i have seted up module from my XinXun Tx to devo 10 today and be able to bind my quad but the control is a bit crazy.

I am not sure how it is called correctly Aileron? When I pull right stick full forward it takes a huge angel and go down how to decrease it ?

Also i am not sure but it looks like i do not have full throttle is there any way to check this?

Try this one see if it works.

If anyone here is familiar with this model could you add the rates and the flip to the above config as it only contains the first four channels so far.

thank you

Guys plz help with this one

Lights turn on/off not working but flip is turned on and not turning off with this code wich i wanted to trigger on GEAR switch



Hovering flight mode Fmode0,
Sport mode Fmode1
Experimental Fmode2

The last flying build

The last stable config for XinXun 39 or any other models wich you want to fly, just replace the protocols,
config for Devo 10 but it will work for most Devos with devention software.

My XinXun39 frame is dead a little bit, so i am waiting for spare parts that's why config a little bit ugly, i will make it more optimized in code and style when i will fix my xinxun.

3 Flight Modes support on FMODE (Right Switch)
0 - Begginers mode, very soft, responsive and nice to fly for beginners.
1 - Advanced mode more aggressive and responsive.
2 - Advanced mode testing.

AUTO FLIP TURN ON/OFF ON GEAR SWITCH

NOTES: XINXUN39 has only 5 channels to control. There is no way to turn on/off lights ;((

nice going to test this now

How it is going ?

Its good, auto flip on and off on channel 5 HOLD0 and 1 is working

I had to disable the 1st mode and just use the 2nd and 3rd as I have a Devo7e
In both advanced flight mode 1 and 2 it is responding very nicely, I didn't bother with flight mode 0

I forgot to mention, when I used your config, ELE and AIL are swapped, needed to change this and it was ok.

For lights control try to move both sticks in the bottom-right corner for 2-3 sec. I have X30 board with Devo7e. It works.